liftmaster garage door opener keypad replacement

Immediately press and hold the LEARN button again until the Learn LED goes out.

Press and hold the LEARN button on garage door opener until the Learn LED goes out (approximately 6 seconds).

All remote controls and keypads have been erased.Įrase all remote controls, keyless entries and MyQ® devices from the garage door opener

Press and hold the LEARN button on the garage door opener until the LED next to the button goes out (approximately 6 seconds).

Units with a green, orange, red, purple or yellow LEARN button: You will need to reprogram them.Įrase all remote controls and keyless entries

Note: Erasing the memory on your opener will clear out any working remotes or keyless entries. The LEARN button may be green, orange, red, purple or yellow, and will have a small LED next to it. You may need to remove a light lens cover or open a control panel to gain access. NOTE: Erasing the memory will remove ALL remote controls and keyless entry codes from the garage door opener.īegin by locating the LEARN button on the back or side of the motor unit generally this is on the same side as the antenna wire. Purchased a new home and want to set garage door opener back to factory default.Your remote control is lost or has been stolen.One remote button is activating multiple doors.Hold the remote control close to the control panel. Choose the button on the HomeLink control panel you want to operate the garage door opener. When the LED light flashes and then goes off, release the buttons. An unwanted remote is activating your garage door opener Press and hold the two exterior buttons simultaneously for about 10 seconds.

There are a few instances that the memory of your opener would need to be erased.

Liftmaster garage door opener keypad replacement